Feb 1, 2008: Second floor beams

Found a local sawmill to cut our second floor beams.
I rented a trailer & brought these to the lot. All I can say is these 4x10 poplar beams were about 200 lbs each!


Dusty!! Jessica is using an electric planer to clean up the rough-cut beams.



Here's a before:

& after planing & sanding:


We used a 2 ton chain hoist to lift the beams onto the girder logs. Worked quite well & safer than trying to get them up a ladder hah.

Comments

Post a Comment

Popular posts from this blog

Second floor 4x10's done and a few windows

Image
 We finished getting all the 4x10's up on the girders, leveled, and secured. Also installed another 3 windows, the two fixed pane in the living room are in, and the slider in the kitchen as well. The next ones and the patio door I'll need Jessica's help with, too heavy to do alone. Cleaned up a little as it was getting messy .  Not too far from starting interior wall framing!!
Read more

Interior clear done

Image
Busy weekend; the interior finish is complete!! We decided to do a clear satin finish. Each log is so unique we felt this would bring out its natural beauty. Lots of work to get them ready for this weekend. - Powerwash 3x - grinded all logs with flap disk - palm sanded inside (60 grit) - scrubbed with cleaning solution - applied a brightner - coated logs in borate (keeps the bugs out!) - applied Pre-Stain #sashcocolorfast - sanded between each coat of clear. We couldn’t be happier! The logs have a soft, smooth texture with a luxurious sheen. Exterior stain this weekend!
Read more

Progress again

Image
 We finished the cleaning, brightening, borate to keep the bugs away, and 20 gallons of pre-stain sprayed last weekend. We started insulating and did a test run with a bag of mortar mix vs mixing it separately like last time. Stain for the outside and clear coat for the inside should be delivered soon, that's next
Read more