December 30, 2007: Girder brackets

These are 1" diameter lag bolts, they'll be used to secure the girder brackets on the front & back.
They were special ordered from a place in Washington.



We had a local guy weld our girder brackets. I cleaned them up with a grinder then primed & painted them.

Here's the front bracket installed. (Using the huge lag bolts from above).


Here's the center bracket. This one is through-bolted with four 1" threaded rods since it has twice the load as the front & back.

Comments

Post a Comment

Popular posts from this blog

Second floor 4x10's done and a few windows

Image
 We finished getting all the 4x10's up on the girders, leveled, and secured. Also installed another 3 windows, the two fixed pane in the living room are in, and the slider in the kitchen as well. The next ones and the patio door I'll need Jessica's help with, too heavy to do alone. Cleaned up a little as it was getting messy .  Not too far from starting interior wall framing!!
Read more

Interior clear done

Image
Busy weekend; the interior finish is complete!! We decided to do a clear satin finish. Each log is so unique we felt this would bring out its natural beauty. Lots of work to get them ready for this weekend. - Powerwash 3x - grinded all logs with flap disk - palm sanded inside (60 grit) - scrubbed with cleaning solution - applied a brightner - coated logs in borate (keeps the bugs out!) - applied Pre-Stain #sashcocolorfast - sanded between each coat of clear. We couldn’t be happier! The logs have a soft, smooth texture with a luxurious sheen. Exterior stain this weekend!
Read more

Progress again

Image
 We finished the cleaning, brightening, borate to keep the bugs away, and 20 gallons of pre-stain sprayed last weekend. We started insulating and did a test run with a bag of mortar mix vs mixing it separately like last time. Stain for the outside and clear coat for the inside should be delivered soon, that's next
Read more